mycnc:wireless_pendants
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:wireless_pendants [2020/03/12 15:29] – ivan | mycnc:wireless_pendants [2020/05/05 09:59] – ivan | ||
---|---|---|---|
Line 115: | Line 115: | ||
These options allow the user to edit every button on their pendant control to their particular configuration if required. For simple pendants included in the defaults list, it is usually recommended to use the default settings. | These options allow the user to edit every button on their pendant control to their particular configuration if required. For simple pendants included in the defaults list, it is usually recommended to use the default settings. | ||
+ | |||
+ | ====XHC wireless pendant control for MS Windows==== | ||
+ | |||
+ | How to install XHC wireless pendant control for MS Windows: | ||
+ | |||
+ | 1. Download the " | ||
+ | |||
+ | {{: | ||
+ | |||
+ | 2. Run the utility, select " | ||
+ | |||
+ | {{: | ||
+ | |||
+ | 3. Select "USB HID" device | ||
+ | |||
+ | {{: | ||
+ | |||
+ | The following ID's are available: | ||
+ | |||
+ | ^^ ID ^^ Pendant Model ^^ | ||
+ | | eb66 | | | ||
+ | | eb6f | PHB02, WHB02 | | ||
+ | | eb93 | WHB04B-6 | | ||
+ | | eb92 | PHB02B-6 | | ||
+ | | eb91 | PHB04B-6 | | ||
+ | | eb70 | WHB04L | | ||
+ | |||
+ | 4. Select " | ||
+ | |||
+ | 5. Restart myCNC software, it should get access to XHC Pendant control over " |
mycnc/wireless_pendants.txt · Last modified: 2022/08/19 15:22 by ivan