Differences

This shows you the differences between two versions of the page.

--- mycnc [2019/10/17 13:30] – ivan
+++ mycnc [2019/10/17 13:30] – ivan
@@ Line 17: / Line 17: @@
   * [[quickstart:mycnc-quick-start:installing-iso-sbc-tinkerboard|Installing the myCNC Linux ISO on a Tinkerboard SBC]]
   * [[quickstart:mycnc-control-board-setup|General myCNC setup]]
-    * [[examples:plasma-x1366p|MyCNC Plasma setup (X1366P)]]
+    * [[examples:plasma-x1366p|Plasma setup (X1366P)]]
-    * [[quickstart:mycnc-quick-start:oxyfuel-setup|MyCNC Oxy-fuel setup (X1366G)]]
+    * [[quickstart:mycnc-quick-start:oxyfuel-setup|Oxy-fuel setup (X1366G)]]
     * [[quickstart:mycnc-quick-start:tangential-knife-setup|Tangential Knife setup (X1366V)]]
   * [[quickstart:mycnc-quick-start:homing_setup|Setting up the homing procedure]]