User Tools

Site Tools


plc:controller_peripherals_test_-_bv17

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
plc:controller_peripherals_test_-_bv17 [2018/07/20 14:04] skirillovplc:controller_peripherals_test_-_bv17 [2018/07/20 14:11] (current) skirillov
Line 58: Line 58:
 In this case, the procedure will be finished immediately without touching any peripherals. \\ Need to save changes, rebuild sources - press 2 buttons on the right of the PLC Builder screen - to apply the changes. In this case, the procedure will be finished immediately without touching any peripherals. \\ Need to save changes, rebuild sources - press 2 buttons on the right of the PLC Builder screen - to apply the changes.
  
-All Software PLC procedures are loaded and started automatically with starting myCNC software except procedures started with (double underline). In later releases, we renamed the procedure from "BV17" to "%%__%%BV17" to remove an issue with automatical enter to test peripherals mode.+All the Software PLC procedures are loaded and started automatically with starting myCNC software except procedures started with (double underline). In later releases, we renamed the procedure from "BV17" to "%%__%%BV17" to remove an issue with automatical enter to test peripherals mode.
  
 To start/stop peripherals test we use on-screen buttons "1" and "0" on diagnose widget. However, any other button anywhere on the GUI can be configured to do the same. To start/stop peripherals test we use on-screen buttons "1" and "0" on diagnose widget. However, any other button anywhere on the GUI can be configured to do the same.
plc/controller_peripherals_test_-_bv17.txt · Last modified: 2018/07/20 14:11 by skirillov

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki