Fulltext results:
- cnc-vision-setup @quickstart:mycnc-quick-start
- n system is controlled through a series of M-code PLCs which can be found in Settings > Config > PLC > Hardware PLC. {{:quickstart:mycnc-quick-start:cnc-vision-033-plc-procedures.png}} The following PLC procedures ar
- lathe_setup @quickstart:mycnc-quick-start
- and turning the necessary ports on and off. M41.plc example <code C M41.plc> //Lathe Low gears #include pins.h #include vars.h //#define input_lathe_low_... rset(9159,1); //display error message message=PLCCMD_MOTION_BREAK; exit(99); }; portclr(o... t(99); }; if (is_modbus!=0) { message=PLCCMD_MODBUS_SPINDLE_SPEED; command=spindle_low_
- probe_setup @quickstart:mycnc-quick-start
- r in Triggers/Timers).// 2. In **CNC Settings > PLC > Hardware PLC**, check that the command **TRIG04** is created. The program should contain the followi... ssage if (gvarget(6060)!=0x57) { message=PLCCMD_MOTION_BREAK; timer=30;do{timer--;}while(t... ck **Generate All Probing Macros** and **Generate PLC Probing procedure M288**. Among other settings, t
- homing_setup @quickstart:mycnc-quick-start
- hysically break it. To prevent this, a Hardware PLC can be used. An example of such a PLC is M286, which is generated automatically for tasks such as Surf... the input port used. The code for M286 Hardware PLC itself is shown below: <code C>////// FILE GENER... 0x4d); }while (1); exit(99); };</code> This PLC will check if the input port is "triggered", and
- mycnc-control-board-setup
- s and outputs are not specified in the particular PLC procedures, but rather referred to (for example, ... t is not necessary to go through all the relevant PLC procedures when an input needs to be changed. Ins... efine in the ''pins.h'' file (Settings > Config > PLC > Hardware PLC > pins.h). When setting up the board, consult the ''pins.h'' file to check which input/
- network-setup @quickstart:mycnc-quick-start
- **Skip Burn ROMFS** toggle allows to skip writing PLC onto the controller every time a new session is s... up time of the myCNC controller if no changes to PLC are planned to be introduced. * **Accept Comma
- oxyfuel-setup @quickstart:mycnc-quick-start
- ntroller to the machine setup, go to **Settings > PLC > Hardware PLC > pins.h**. The current output configuration can be found on the screen such as the one
- start-stop-setup @quickstart:mycnc-quick-start
- al information on Program Stop and the associated PLC procedures is available here: [[mycnc:stop_end_pr... in procedures such as the HOMING_HANDLER Software PLC. Additionally, the following global variables c