Fulltext results:
- plasma-x1366p
- ial sheet. Both inputs should be configured in [[plc:plc|PLC]] Builder, in the **pins.h** file which can be accessed by going to ''Settings > Config > PLC > Hardware PLC''. Either of these can also be re-
- plasma-1024p
- erial sheet. Both inputs should be configured in PLC Builder, include file **pins.h** <code pins.h> #d... bers for Plasma power source should be defined in PLC Builder, **pins.h** include file <code c pins.h>... put numbers for external THC should be defined in PLC Builder, **pins.h** include file <code c pins.h>... iber turned on by code M72 and turned off by M73. PLC procedures **M72.plc**, **M73.plc** should handle
- disable-arc-on @examples:plasma-x1366p
- assigned in the pins.h file (Settings > Config > PLC > Hardware PLC > pins.h) under ''#define INPUT_ARC'' - Check on-board LED correspondent to the cor... ) Remove the following pieces of code for the M71.plc source, then save, rebuild and send the binary files (press 3 buttons on the right of **PLC Builder** screen. <code C> timer=5000; //wait up
- plasma-x1366l
- mer--;}while(timer>0); }; </code> <code c M05.plc> //Spindle Stop #define command var00 #define par... op(); }; m5_et10(); //m5_modbus(); proc=plc_proc_idle; check_m5_encoder(); gvarset(7370... t(99); //normal exit }; </code> <code c M03.plc> //Turn on Spindle clockwise #include pins.h #in... eed Mirror register //check_shoulder(); proc=plc_proc_spindle; //m3_modbus(); m3_et10(); c