Fulltext results:
- plasma-x1366p
- neral, using these examples as the basis for your PLCs/macro commands allows for an easier setup proces... ial sheet. Both inputs should be configured in [[plc:plc|PLC]] Builder, in the **pins.h** file which can be accessed by going to ''Settings > Config > PLC > Ha
- plasma-1024p
- neral, using these examples as the basis for your PLCs/macro commands allows for an easier setup proces... erial sheet. Both inputs should be configured in PLC Builder, include file **pins.h** <code pins.h> #d... bers for Plasma power source should be defined in PLC Builder, **pins.h** include file <code c pins.h>... put numbers for external THC should be defined in PLC Builder, **pins.h** include file <code c pins.h>
- disable-arc-on @examples:plasma-x1366p
- assigned in the pins.h file (Settings > Config > PLC > Hardware PLC > pins.h) under ''#define INPUT_ARC'' - Check on-board LED correspondent to the cor... ) Remove the following pieces of code for the M71.plc source, then save, rebuild and send the binary files (press 3 buttons on the right of **PLC Builder** screen. <code C> timer=5000; //wait up
- plasma-x1366l
- ) { pwm02=0; speed=0; channel=2; message=PLCCMD_SET_CNC_EXTVAR; command=0x32; parameter=19... w_speed() { speed=200; channel=2; message=PLCCMD_SET_CNC_EXTVAR; command=0x32; parameter=19... mer--;}while(timer>0); }; </code> <code c M05.plc> //Spindle Stop #define command var00 #define par... op(); }; m5_et10(); //m5_modbus(); proc=plc_proc_idle; check_m5_encoder(); gvarset(7370