Fulltext results:
- probe_setup
- r in Triggers/Timers).// 2. In **CNC Settings > PLC > Hardware PLC**, check that the command **TRIG04** is created. The program should contain the followi... ck **Generate All Probing Macros** and **Generate PLC Probing procedure M288**. Among other settings, t... ng procedure, head into **CNC Settings > Config > PLC > Hardware PLC** and click the **Save All**, **Bu
- lathe_setup
- and turning the necessary ports on and off. M41.plc example <code C M41.plc> //Lathe Low gears #include pins.h #include vars.h //#define input_lathe_low_... 99); //normal exit }; </code> A simple M41.plc example <code C M41.plc> //Lathe Low gears #include pins.h #include vars.h main() { portclr(output_
- homing_setup
- hysically break it. To prevent this, a Hardware PLC can be used. An example of such a PLC is M286, which is generated automatically for tasks such as Surf... the input port used. The code for M286 Hardware PLC itself is shown below: <code C>////// FILE GENER... 0x4d); }while (1); exit(99); };</code> This PLC will check if the input port is "triggered", and
- cnc-vision-setup
- de PLCs which can be found in Settings > Config > PLC > Hardware PLC. {{:quickstart:mycnc-quick-start:cnc-vision-033-plc-procedures.png}} The following PLC procedures are used: * M395 - camera calibration. ++ Show M395
- network-setup
- **Skip Burn ROMFS** toggle allows to skip writing PLC onto the controller every time a new session is s... up time of the myCNC controller if no changes to PLC are planned to be introduced. * **Accept Comma
- oxyfuel-setup
- ntroller to the machine setup, go to **Settings > PLC > Hardware PLC > pins.h**. The current output configuration can be found on the screen such as the one
- start-stop-setup
- al information on Program Stop and the associated PLC procedures is available here: [[mycnc:stop_end_pr... in procedures such as the HOMING_HANDLER Software PLC. Additionally, the following global variables c