plc:plc_procedure_aliases
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
plc:plc_procedure_aliases [2017/09/12 18:26] – skirillov | plc:plc_procedure_aliases [2017/09/12 18:27] (current) – skirillov | ||
---|---|---|---|
Line 5: | Line 5: | ||
* М74 - Cutting Off | * М74 - Cutting Off | ||
- | Q: What to do if need to cut g-code file from different CA</postprocessor | + | Q: What to do if need to cut g-code file from different CA</post-processor |
We need to run this codes M3/M5 exactly as our current codes М71/М74. There are 2 solutions in this case - bad and good :). | We need to run this codes M3/M5 exactly as our current codes М71/М74. There are 2 solutions in this case - bad and good :). | ||
Line 16: | Line 16: | ||
- Click in window **PLC Sources** line with Procedure М71 | - Click in window **PLC Sources** line with Procedure М71 | ||
- On the top-right side of PLC Builder window there will be Input Line for **Aliases**. Enter **M3** name there (if there are other names, add M3 with ";" | - On the top-right side of PLC Builder window there will be Input Line for **Aliases**. Enter **M3** name there (if there are other names, add M3 with ";" | ||
- | - Clic in **PLC Sources** om any other line AND CHECK if in the line with **M71** appear **M3** in brackets {{mycnc: | + | - Click in **PLC Sources** om any other line AND CHECK if in the line with **M71** appear **M3** in brackets {{mycnc: |
- Do the same for **M74** and add **M5** procedure as Alias {{mycnc: | - Do the same for **M74** and add **M5** procedure as Alias {{mycnc: | ||
- Press in series 3 buttons on righ side of PLC Builder - **Build All**, **Save All**, **Send** {{mycnc: | - Press in series 3 buttons on righ side of PLC Builder - **Build All**, **Save All**, **Send** {{mycnc: | ||
М3 and М5 are ready to go! | М3 and М5 are ready to go! |
plc/plc_procedure_aliases.txt · Last modified: 2017/09/12 18:27 by skirillov