quickstart:mycnc-quick-start:cnc-vision-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
quickstart:mycnc-quick-start:cnc-vision-setup [2020/01/13 09:33] – ivan | quickstart:mycnc-quick-start:cnc-vision-setup [2020/01/16 10:14] – ivan | ||
---|---|---|---|
Line 4: | Line 4: | ||
//Please note that the Vision System license for correcting the generated G-code using visual markers is a separate license that must be purchased in addition to the myCNC controller in order to be enabled (available as part of the [[https:// | //Please note that the Vision System license for correcting the generated G-code using visual markers is a separate license that must be purchased in addition to the myCNC controller in order to be enabled (available as part of the [[https:// | ||
+ | |||
+ | A video with the recap of the manual below is available here: | ||
+ | |||
+ | {{youtube> | ||
In order to set up the camera, you must go into the **CNC Settings > Config > Camera**. The screen presented to you will be the one shown below: | In order to set up the camera, you must go into the **CNC Settings > Config > Camera**. The screen presented to you will be the one shown below: |
quickstart/mycnc-quick-start/cnc-vision-setup.txt · Last modified: 2024/02/26 14:50 by ivan