quickstart:mycnc-quick-start:cnc-vision-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
quickstart:mycnc-quick-start:cnc-vision-setup [2020/01/16 12:21] – ivan | quickstart:mycnc-quick-start:cnc-vision-setup [2020/01/16 14:04] – ivan | ||
---|---|---|---|
Line 216: | Line 216: | ||
NOTE: The program will not begin the main cutting process unless all the markers that were expected to be adjusted for have been located. | NOTE: The program will not begin the main cutting process unless all the markers that were expected to be adjusted for have been located. | ||
+ | |||
+ | |||
+ | =====Camera troubleshooting===== | ||
+ | |||
+ | A camera troubleshooting guide is available here: [[troubleshooting: |
quickstart/mycnc-quick-start/cnc-vision-setup.txt · Last modified: 2024/02/26 14:50 by ivan