quickstart:mycnc-quick-start:cnc-vision-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
quickstart:mycnc-quick-start:cnc-vision-setup [2020/01/16 14:07] – ivan | quickstart:mycnc-quick-start:cnc-vision-setup [2020/03/03 14:29] – ivan | ||
---|---|---|---|
Line 20: | Line 20: | ||
* In the case of the particular marker used in this scenario, its size has been set to 160 pixels, which is on the low end of the relative pattern size - a larger pattern size is typically a safer choice in low-light conditions. | * In the case of the particular marker used in this scenario, its size has been set to 160 pixels, which is on the low end of the relative pattern size - a larger pattern size is typically a safer choice in low-light conditions. | ||
* NOTE: The camera focus must be properly adjusted in order for the camera to recognize markers. | * NOTE: The camera focus must be properly adjusted in order for the camera to recognize markers. | ||
+ | {{: | ||
{{: | {{: |
quickstart/mycnc-quick-start/cnc-vision-setup.txt · Last modified: 2024/02/26 14:50 by ivan