quickstart:mycnc-quick-start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
quickstart:mycnc-quick-start [2017/07/13 20:04] – skirillov | quickstart:mycnc-quick-start [2019/04/16 11:54] – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
==== MyCNC Quick Start ==== | ==== MyCNC Quick Start ==== | ||
+ | |||
+ | ===Installing Ubuntu MATE 16.04 through LiveCD with preinstalled myCNC software=== | ||
+ | *The LiveCD image can either be burned onto a DVD, or written on a USB disk through the use of [[https:// | ||
+ | *Connect the power cable, the screen through the HDMI or VGA cable, keyboard, mouse and the LiveCD with Ubuntu Mate 16.04 to the computer | ||
+ | *When booting up the computer, hold the Delete key to enter the BIOS | ||
+ | {{ : | ||
+ | *In the BIOS screen, navigate to the **Boot** tab | ||
+ | {{ : | ||
+ | *Select the **Hard Drive BBS Priorities** | ||
+ | *For **Boot Option #1**, switch the SSD 32GB to KingstonDT 101 G2 PMAP | ||
+ | {{ : | ||
+ | *Save & Exit by pressing F10. The boot-up will begin shortly | ||
+ | *In the popup window, select the **Install Ubuntu MATE** option | ||
+ | {{ : | ||
+ | *Select **Normal Installation**, | ||
+ | {{ : | ||
+ | *Select the **Erase disk and install Ubuntu MATE option** if you want to format the Windows partition, leaving only Ubuntu MATE on the computer | ||
+ | {{ : | ||
+ | *Select your timezone | ||
+ | *In the //Who are you?// screen, use **mycnc** as the username to access the presets that are applied during the installation of the myCNC software. NOTE: These presets include the **mycnc** user in groups such as dialout (scanners), sudo (security privileges of superuser), and sambashare (SMB/CIFS networking protocol for Windows). These presets are strongly recommended for novice users. | ||
+ | *Select the **Log in automatically** option | ||
+ | {{ : | ||
+ | The installation of Ubuntu MATE will begin momentarily. | ||
+ | |||
+ | ===Setting up the myCNC control board=== | ||
* Connect 24V DC power supply to myCNC control board | * Connect 24V DC power supply to myCNC control board |
quickstart/mycnc-quick-start.txt · Last modified: 2020/09/14 09:14 by ivan