quickstart:mycnc-quick-start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
quickstart:mycnc-quick-start [2017/07/13 20:04] – skirillov | quickstart:mycnc-quick-start [2019/09/19 09:43] – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
==== MyCNC Quick Start ==== | ==== MyCNC Quick Start ==== | ||
- | * Connect 24V DC power supply to myCNC control board | + | * [[quickstart: |
- | * Here are power-up examples for ET6, ET7, ET10 control boards | + | |
- | * Connect myCNC Ethernet controller with Network cable directly to Host computer or to Network Router. If use Odroid-C2 (Raspberry-Pi3) computers as a Host, Network cable is a short 0.5ft cable between Odroid & Controller {{mycnc:et6-odroid-network-cable.jpg}} | + | * [[quickstart: |
- | * Setup Network addresses for Host computer and myCNC Ethernet controller. Addresses of Controller and Host should be in same local network. For Example - < | + | |
- | Host Address: 192.168.0.100</ | + | * [[quickstart:mycnc-control-board-setup|myCNC control board setup]] |
- | Host Address: 192.168.5.11</ | + | |
- | * Goto MyCNC software, Cfg Settings, Network Tab and | + | |
- | * Set actual Controller IP address | + | |
- | * Set " | + | * [[mycnc: |
- | * press " | + | |
- | * Changes should be applied on the fly and **UDP message counter** should start counting which means communication between Controller & Host works correct. {{mycnc::mycnc-quickstart-network-settings-01.png}} | + | |
- | * Connect Pulse-Dir signals from servo or stepper driver to myCNC control board {{hardware:et6-stepper-driver-connection-001.png}} | + | |
- | * Check what minimal pulse width your drivers accept and set pulse width of myCNC control board accordingly (equal or more) in MyCNC software | + | |
+ | |||
+ | | ||
+ | |||
+ | * [[quickstart:mycnc-quick-start:start-stop-setup|Start/ | ||
+ | |||
+ | * [[quickstart: | ||
+ | |||
+ | * [[quickstart:mycnc-quick-start: | ||
+ | |||
+ | * [[quickstart: | ||
+ | |||
+ | * [[quickstart: | ||
quickstart/mycnc-quick-start.txt · Last modified: 2020/09/14 09:14 by ivan