quickstart:mycnc-quick-start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
quickstart:mycnc-quick-start [2019/04/23 09:26] – ivan | quickstart:mycnc-quick-start [2019/07/08 11:06] – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
==== MyCNC Quick Start ==== | ==== MyCNC Quick Start ==== | ||
- | [[http:// | + | |
- | ===Setting up the myCNC control board=== | + | |
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
+ | |||
+ | | ||
- | * Connect 24V DC power supply to myCNC control board | ||
- | * Here are power-up examples for ET6, ET7, ET10 control boards | ||
- | * Connect myCNC Ethernet controller with Network cable directly to Host computer or to Network Router. If use Odroid-C2 (Raspberry-Pi3) computers as a Host, Network cable is a short 0.5ft cable between Odroid & Controller {{mycnc: | ||
- | * Setup Network addresses for Host computer and myCNC Ethernet controller. Addresses of Controller and Host should be in same local network. For Example - < | ||
- | Host Address: 192.168.0.100</ | ||
- | Host Address: 192.168.5.11</ | ||
- | * Goto MyCNC software, Cfg Settings, Network Tab and | ||
- | * Set actual Controller IP address to " | ||
- | * Set " | ||
- | * press " | ||
- | * Changes should be applied on the fly and **UDP message counter** should start counting which means communication between Controller & Host works correct. {{mycnc:: | ||
- | * Connect Pulse-Dir signals from servo or stepper driver to myCNC control board {{hardware: | ||
- | * Check what minimal pulse width your drivers accept and set pulse width of myCNC control board accordingly (equal or more) in MyCNC software -> Cfg Settings -> Hardware Tab -> Common Hardware Settings {{mycnc: | ||
quickstart/mycnc-quick-start.txt · Last modified: 2020/09/14 09:14 by ivan