quickstart:mycnc-quick-start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
quickstart:mycnc-quick-start [2019/04/16 12:21] – ivan | quickstart:mycnc-quick-start [2019/04/23 09:26] – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
==== MyCNC Quick Start ==== | ==== MyCNC Quick Start ==== | ||
- | ===Installing Ubuntu MATE 16.04 through LiveCD with preinstalled myCNC software=== | + | [[http://www.cnc42.com/quickstart/installing_ubuntu_mate|Installing Ubuntu MATE 16.04 through LiveCD with preinstalled myCNC software]] |
- | *The LiveCD image can either be burned onto a DVD, or written on a USB disk through the use of [[https://www.balena.io/etcher/|Etcher]] or [[https:// | + | |
- | *Connect the power cable, the screen | + | |
- | *When booting up the computer, hold the **Delete** key to enter the BIOS | + | |
- | {{ : | + | |
- | *In the BIOS screen, navigate to the **Boot** tab | + | |
- | {{ : | + | |
- | *Select the **Hard Drive BBS Priorities** | + | |
- | *For **Boot Option #1**, switch the SSD 32GB to KingstonDT 101 G2 PMAP | + | |
- | {{ : | + | |
- | *Save & Exit by pressing F10. The boot-up will begin shortly | + | |
- | *In the popup window, select the **Install Ubuntu MATE** option | + | |
- | {{ : | + | |
- | *Select **Normal Installation**, | + | |
- | {{ : | + | |
- | *Select the **Erase disk and install Ubuntu MATE** option if you want to format the Windows partition, leaving only Ubuntu MATE on the computer | + | |
- | {{ : | + | |
- | *Select your timezone | + | |
- | *In the //Who are you?// screen, use **mycnc** as the username to access the presets that are applied during the installation. These presets include the **mycnc** user in groups such as dialout (access to scanners), sudo (security privileges of superuser), and sambashare (SMB/CIFS networking protocol for Windows). NOTE: These presets are strongly recommended for novice users. | + | |
- | *Select the **Log in automatically** option | + | |
- | {{ : | + | |
- | + | ||
- | The installation of Ubuntu MATE will begin momentarily. | + | |
===Setting up the myCNC control board=== | ===Setting up the myCNC control board=== |
quickstart/mycnc-quick-start.txt · Last modified: 2020/09/14 09:14 by ivan