Differences

This shows you the differences between two versions of the page.

--- spindle_speed_control_through_-10v_dac_channel_et10 [2017/12/01 00:42] – es
+++ spindle_speed_control_through_-10v_dac_channel_et10 [2018/08/31 10:00] (current) – skirillov
@@ Line 12: / Line 12: @@
 === PLC controller (Hardware) ===
+!!!! [[mycnc:closed_loop_configuration#analogue_-10v10v_outputs_test_mode|Please check if the DACs are not in the test mode before using.]] !!!
 DAC offset register is mapped to address 0x32 of [[mycnc:extern_variables|Extern CNC Variables]] Area.
@@ Line 20: / Line 24: @@
 high 4 bits is DAC channel
-Message PLCCMD_SET_CNC_EXTVAR should be sent to myCNC control core from PLC to get access [[External CNC Variables]], then 2 ms delay should be initiated to push the message from PLC to myCNC Core.
+Message PLCCMD_SET_CNC_EXTVAR should be sent to myCNC control core from PLC to get access [[mycnc:extern_variables|Extern CNC Variables]], then 2 ms delay should be initiated to push the message from PLC to myCNC Core.
 <code c>#define PLCCMD_SET_CNC_EXTVAR 1020</code>