thc:thc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
thc:thc [2019/11/05 15:01] – ivan | thc:thc [2019/11/28 10:11] – ivan | ||
---|---|---|---|
Line 99: | Line 99: | ||
17. Set the **Cutting pre-off** value (in seconds). This allows to stop the cutting some fraction of a second before the machine stops moving at its working speed and may be useful to some users/ | 17. Set the **Cutting pre-off** value (in seconds). This allows to stop the cutting some fraction of a second before the machine stops moving at its working speed and may be useful to some users/ | ||
- | 18. Select whether you want to accept jog while THC is activated. This allows for jog in the z-axis while THC is on in order to allow the user to lift/lower the torch manually | + | 18. Select whether you want to **accept jog while THC is activated**. This allows for jog in the z-axis while THC is on in order to allow the user to lift/lower the torch manually |
{{: | {{: | ||
+ | |||
+ | When this setting is turned ON, it is possible to set up a set of hard keys / buttons which will allow the operator to quickly adjust the THC position. To do this, head into '' | ||
+ | |||
+ | {{ : | ||
+ | |||
+ | When the keys are then pressed during the cutting process, the THC Position will reflect that by going up/down: | ||
+ | |||
+ | {{ : | ||
19. Select the **THC Jog speed ratio**. This is usually set to be an order of magnitude lower than the working speed, as to not move the torch erratically. | 19. Select the **THC Jog speed ratio**. This is usually set to be an order of magnitude lower than the working speed, as to not move the torch erratically. |
thc/thc.txt · Last modified: 2023/12/28 14:10 by ivan