Differences

This shows you the differences between two versions of the page.

--- thc:thc [2019/11/28 10:04] – ivan
+++ thc:thc [2019/11/28 10:11] – ivan
@@ Line 99: / Line 99: @@
 . Set the **Cutting pre-off** value (in seconds). This allows to stop the cutting some fraction of a second before the machine stops moving at its working speed and may be useful to some users/operators depending on their cutting needs and machine configuration. This value can be set to 0 if not required by the user.
-. Select whether you want to **accept jog while THC is activated**. This allows for jog in the z-axis while THC is on in order to allow the user to lift/lower the torch manually (for example, to inspect it). This field can be set to OFF if the user does not want to be able to accidentally move the torch during the cutting process while the THC is ON.
+. Select whether you want to **accept jog while THC is activated**. This allows for jog in the z-axis while THC is on in order to allow the user to lift/lower the torch manually through operator inputs in addition to the regular THC control. This field can be set to OFF if the user does not want to be able to accidentally move the torch during the cutting process while the THC is ON.
 {{:thc:thc-setup-010-accept-jog.png}}
@@ Line 107: / Line 107: @@
 {{ :thc:thc-jog-001-hardkeys.png}}
-When the keys are then pressed during the cutting process, the THC position will reflect that by going up/down.
+When the keys are then pressed during the cutting process, the THC Position will reflect that by going up/down:
+{{ :thc:thc-jog-003-position.png}}
 . Select the **THC Jog speed ratio**. This is usually set to be an order of magnitude lower than the working speed, as to not move the torch erratically.