Differences

This shows you the differences between two versions of the page.

--- thc:thc [2019/11/28 10:15] – ivan
+++ thc:thc [2019/12/30 13:33] – ivan
@@ Line 56: / Line 56: @@
     - Make a test straight cut and check Arc Voltage during the cut (it is "96V" for the setup below). \\ \\ {{hardware:thc:mycnc-thc-011.png}}
-This second method is recommended for more experienced users who want more granularity and quality control.
+This second method is recommended for the more experienced users.
 **5.** Select the proper ratio, as described in the Initial Setup part.
@@ Line 117: / Line 117: @@
 The next step is to check if THC is ON in the User Settings.
-It can be a button in User settings of an item in PLC settings. Both settings will turn THC on/off and both represent the same variables - the user can decide which one they want to use out of convenience.
+It can be a button in User settings, or a toggle in the PLC settings (Settings > PLC). Both settings will turn THC on/off and both represent the same variables - the user can decide which one they want to use out of convenience. Typically, the User Settings window is used.
 {{:thc:thc-setup-user-settings-001.png}}