thc:thc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
thc:thc [2020/02/19 13:04] – ivan | thc:thc [2020/02/19 13:45] – ivan | ||
---|---|---|---|
Line 69: | Line 69: | ||
**8.** Set the **THC Low Speed, [%] of feedrate** value. Whenever the speed of the machine will fall lower than this percentage of the feedrate, the possibility of the arc voltage fluctuating rises greatly. Thus, to prevent the torch from diving, the last height value before the speed goes below your THC Low Speed percentage value is taken and maintained until the speed rises back up again. | **8.** Set the **THC Low Speed, [%] of feedrate** value. Whenever the speed of the machine will fall lower than this percentage of the feedrate, the possibility of the arc voltage fluctuating rises greatly. Thus, to prevent the torch from diving, the last height value before the speed goes below your THC Low Speed percentage value is taken and maintained until the speed rises back up again. | ||
+ | |||
+ | The below diagram illustrates the way THC Low Speed works. On corners (green), the speed falls below the typical Feedrate #1 (red), so it can be used to disable THC on sharp corners. Feedrate #2 (blue), which is typically different from Feedrate #1, is used for hole and arc cutting. This way, THC will still be ON at smooth corners: | ||
+ | |||
+ | {{: | ||
**9.** Select the Hi/Lo event output port (63 by default). | **9.** Select the Hi/Lo event output port (63 by default). |
thc/thc.txt · Last modified: 2023/12/28 14:10 by ivan