thc:thc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
thc:thc [2020/02/19 13:45] – ivan | thc:thc [2020/03/13 10:17] – ivan | ||
---|---|---|---|
Line 170: | Line 170: | ||
* **IHC Cutting Height**. After the pierce time has elapsed, the machine moves the torch to the cutting height at which the cutting will begin. | * **IHC Cutting Height**. After the pierce time has elapsed, the machine moves the torch to the cutting height at which the cutting will begin. | ||
* **THC Start Delay** signifies the time for which Torch Height Control is not turned on after the cutting has started (to prevent metal splashes/ | * **THC Start Delay** signifies the time for which Torch Height Control is not turned on after the cutting has started (to prevent metal splashes/ | ||
- | * **THC Pre-off time**. In order to prevent sudden movements due to rapid voltage changes as a cut (especially when cutting a hole) is done, THC can be turned off some time before the end of the cut and the machine will be kept at a set height until the THC system will move to the next cut. | + | * **THC Pre-off time**. In order to prevent sudden movements due to rapid voltage changes as a cut (especially when cutting a hole) is finishing up, THC can be turned off some time before the end of the cut and the machine will be kept at a set height until the THC system will move to the next cut. |
* **Lift After Cut Height** to move the torch up to after the cut has completed. | * **Lift After Cut Height** to move the torch up to after the cut has completed. | ||
thc/thc.txt · Last modified: 2023/12/28 14:10 by ivan