thc:thc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
thc:thc [2020/03/13 10:17] – ivan | thc:thc [2020/10/09 11:21] – ivan | ||
---|---|---|---|
Line 149: | Line 149: | ||
* **_Table** - similar to regular Table, with a predefined value for the reference voltage, however the THC Start Delay WILL be used. | * **_Table** - similar to regular Table, with a predefined value for the reference voltage, however the THC Start Delay WILL be used. | ||
* **_Measure** - similar to regular Measure, the reference voltage value is recorded by the controller prior to the THC Start. THC Start Delay WILL be used. | * **_Measure** - similar to regular Measure, the reference voltage value is recorded by the controller prior to the THC Start. THC Start Delay WILL be used. | ||
+ | * **Measure 1V** - the reference voltage is measured (similar to the **Measure** setting), but if the voltage has changed a lot relative to the previous reference voltage, then the new value will change no more than the specified value (for example 1V) | ||
+ | * For example, if the previous voltage was 125, and 130 was the new measured value, then the new reference voltage will be set to 126 | ||
+ | * The maximum reference voltage change is set in the THC settings (Settings > Config > Technology > THC): | ||
+ | {{: | ||
+ | * **_Measure 1V** - similar to regular Measure 1V, with the THC Start Delay. | ||
A skilled operator can also control the reference arc voltage, if necessary, to bring the torch up/down, however the system allows for a fully automatic Torch Height Control through these settings. | A skilled operator can also control the reference arc voltage, if necessary, to bring the torch up/down, however the system allows for a fully automatic Torch Height Control through these settings. |
thc/thc.txt · Last modified: 2023/12/28 14:10 by ivan