Differences

This shows you the differences between two versions of the page.

--- troubleshooting:troubleshooting [2020/01/16 12:18] – ivan
+++ troubleshooting:troubleshooting [2022/01/10 15:45] (current) – ivan
@@ Line 1: / Line 1: @@
 ====== Troubleshooting ======
-* [[troubleshooting:hardware_checklist|Hardware Troubleshooting Checklist]]
+[[:faq|Frequently Asked Questions section]] - useful for initial setup
-* [[troubleshooting:no_connection|No Connection between myCNC controller and a Host computer]]
+----
-* [[troubleshooting:change_profile|How to change profile from Linux Desktop]]
-* [[troubleshooting:restore_profile|How to restore profiles]]
+  * [[troubleshooting:hardware_checklist|Hardware Troubleshooting Checklist]]
-* [[troubleshooting:rollback_mycnc|How to rollback to a previous version of myCNC software]]
+  * [[troubleshooting:no_connection|No Connection between myCNC controller and a Host computer]]
+    * [[quickstart:mycnc-quick-start:network-setup|Network Setup - General Setup Tips]]
+    * [[mycnc:change_ip_address_of_mycnc_control_board|How to change IP Address of myCNC control board - Linux]]
+    * [[mycnc:change_ip_address_of_single_board_computer_sbc|How to change IP address for an Ubuntu MATE Computer]]
+    * [[mycnc:change_ip_address_for_tinkerboard_sbc|How to change IP Address for TinkerBoard SBC]]
+    * [[troubleshooting:no_connection:windows7|How to set up connection with a Windows computer]]
-* [[troubleshooting:thc_troubleshooting|THC Troubleshooting]]
+  * [[troubleshooting:change_profile|How to change profile from Linux Desktop]]
-* [[troubleshooting:camera_troubleshooting|Camera Troubleshooting]]
+  * [[troubleshooting:restore_profile|How to restore profiles]]
+  * [[troubleshooting:rollback_mycnc|How to rollback to a previous version of myCNC software]]
+  * [[troubleshooting:thc_troubleshooting|THC Troubleshooting]]
+  * [[troubleshooting:camera_troubleshooting|Camera Troubleshooting]]
+  * [[troubleshooting:File_System_check|File System Checkup (The software does not start)]]
+  * [[troubleshooting:overlayroot_read_only|Changing read-only system behaviour]]