plc:plc_gas_cutting_implementation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| plc:plc_gas_cutting_implementation [2017/06/07 00:37] – skirillov | plc:plc_gas_cutting_implementation [2017/06/07 00:44] – skirillov | ||
|---|---|---|---|
| Line 148: | Line 148: | ||
| in Start Cutting PLC procedure should be handler to monitor "break heating" | in Start Cutting PLC procedure should be handler to monitor "break heating" | ||
| - | < | + | < |
| #include pins.h | #include pins.h | ||
| #include vars.h | #include vars.h | ||
| Line 288: | Line 288: | ||
| === Gas Cutting Control with Initial Height positioning === | === Gas Cutting Control with Initial Height positioning === | ||
| - | {{gas-control-004.png? | + | {{mycnc-plc-gas-control-004.png? |
| * H1 - Safe Height, defined as distance from cutting height at the end of previous cut. Ignition process started on Safe Height. A system waits 1-2 seconds for stable flame process, then switch to Preheat Process and moves torch down to - | * H1 - Safe Height, defined as distance from cutting height at the end of previous cut. Ignition process started on Safe Height. A system waits 1-2 seconds for stable flame process, then switch to Preheat Process and moves torch down to - | ||
plc/plc_gas_cutting_implementation.txt · Last modified: 2021/11/02 17:20 by ivan