faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
faq [2020/01/21 09:25] – ivan | faq [2020/01/24 09:04] – ivan | ||
---|---|---|---|
Line 82: | Line 82: | ||
If nothing comes up, write to us using our [[https:// | If nothing comes up, write to us using our [[https:// | ||
+ | |||
+ | ++++ | ||
+ | |||
+ | ++++ How to set up homing? | | ||
+ | |||
+ | The following video is available to aid the user with the homing procedure setup. | ||
+ | |||
+ | {{youtube> | ||
+ | |||
+ | A full manual is available here: [[quickstart: | ||
++++ | ++++ | ||
Line 164: | Line 174: | ||
{{mycnc: | {{mycnc: | ||
+ | |||
+ | ++++ | ||
+ | |||
+ | ++++ How to change the program units (mm and inches)? | | ||
+ | |||
+ | A quick video on switching mm to inches is available: | ||
+ | |||
+ | {{youtube> | ||
++++ | ++++ | ||
Line 210: | Line 228: | ||
The Run from Here method is described in the following section of the myCNC Screen manual: [[http:// | The Run from Here method is described in the following section of the myCNC Screen manual: [[http:// | ||
+ | |||
+ | ++++ | ||
=====Plasma===== | =====Plasma===== |
faq.txt · Last modified: 2024/02/20 10:07 by ivan