faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
faq [2020/04/09 13:15] – ivan | faq [2020/06/05 13:10] – ivan | ||
---|---|---|---|
Line 5: | Line 5: | ||
++++ Is a PC required to use the myCNC controller? | | ++++ Is a PC required to use the myCNC controller? | | ||
- | Yes, a PC is required to run the myCNC software, which will be used to control the myCNC board. You can use a full industrial PC (such as the one provided in some controller kits in our Shop), or you can use a small single board computer, such as a Raspberry Pi, an Odroid or a TinkerBoard. The links to download the myCNC software are available at our [[https:// | + | Yes, a PC is required to run the myCNC software, which will be used to control the myCNC board. You can use a full industrial PC (such as the one provided in some controller kits in our Shop), or you can use a small single board computer, such as a Raspberry Pi, an Odroid or a TinkerBoard. The links to download the myCNC software are available at our [[https:// |
++++ | ++++ | ||
+ | |||
+ | ++++ Is a myCNC controller required to use the myCNC software? | | ||
+ | |||
+ | Yes, a myCNC controller is needed to use most of the functions of the myCNC software. The main software itself is free and can be downloaded from our [[https:// | ||
+ | |||
+ | The software can be downloaded and tested in Simulation mode, designed to help the user get a feel for the software layout and functions. However, the Simulation mode is highly restrictive, | ||
+ | |||
+ | ++++ | ||
+ | |||
====Software Setup==== | ====Software Setup==== | ||
+ | |||
+ | |||
+ | ++++ What are the login credentials for a computer running a custom Linux build? | | ||
+ | |||
+ | The login credentials for all Linux computers using the myCNC Ubuntu MATE installation are the following: | ||
+ | |||
+ | Login: **mycnc** | ||
+ | |||
+ | Password: **operator** | ||
+ | |||
+ | ++++ | ||
++++ How do I navigate the myCNC software? | | ++++ How do I navigate the myCNC software? | | ||
Line 227: | Line 247: | ||
The '' | The '' | ||
+ | |||
+ | ++++ | ||
+ | |||
+ | ++++ Why is the tool change macro M6 not working? | | ||
+ | |||
+ | Check that the M6TXX tool change commands are accepted by the myCNC software (Settings > Config > G-codes settings > Tool Change M6TXX): | ||
+ | |||
+ | {{:: | ||
++++ | ++++ | ||
Line 293: | Line 321: | ||
* Check that the reference voltage has been chosen correctly | * Check that the reference voltage has been chosen correctly | ||
{{hardware: | {{hardware: | ||
- | * In Settings > Config > Technology > THC, check that the Alarm Arc Voltage Difference and Alarm Arc Voltage Rise aren't set to a value that's too low - in cases where the reference and the measured voltage | + | * In Settings > Config > Technology > THC, check that the Alarm Arc Voltage Difference and Alarm Arc Voltage Rise aren't set to a value that's too low - in cases where the difference between |
{{: | {{: | ||
* Check that THC is enabled in the User Settings | * Check that THC is enabled in the User Settings |
faq.txt · Last modified: 2024/02/20 10:07 by ivan