faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
faq [2020/01/02 11:02] – ivan | faq [2020/01/24 09:04] – ivan | ||
---|---|---|---|
Line 8: | Line 8: | ||
++++ | ++++ | ||
+ | |||
+ | |||
+ | ++++ How do I navigate the myCNC software? | | ||
+ | |||
+ | A short introduction to myCNC software is available here: | ||
+ | |||
+ | {{youtube> | ||
+ | |||
+ | If you would like more information about all the particular buttons and on-screen elements in a particular myCNC profile, please consult the [[mycnc: | ||
+ | |||
+ | ++++ | ||
++++ Why is there no connection between my computer and the myCNC controller? | | ++++ Why is there no connection between my computer and the myCNC controller? | | ||
Line 71: | Line 82: | ||
If nothing comes up, write to us using our [[https:// | If nothing comes up, write to us using our [[https:// | ||
+ | |||
+ | ++++ | ||
+ | |||
+ | ++++ How to set up homing? | | ||
+ | |||
+ | The following video is available to aid the user with the homing procedure setup. | ||
+ | |||
+ | {{youtube> | ||
+ | |||
+ | A full manual is available here: [[quickstart: | ||
++++ | ++++ | ||
Line 153: | Line 174: | ||
{{mycnc: | {{mycnc: | ||
+ | |||
+ | ++++ | ||
+ | |||
+ | ++++ How to change the program units (mm and inches)? | | ||
+ | |||
+ | A quick video on switching mm to inches is available: | ||
+ | |||
+ | {{youtube> | ||
++++ | ++++ | ||
Line 191: | Line 220: | ||
* **Edit XML config item** experimental dialog will be shown. | * **Edit XML config item** experimental dialog will be shown. | ||
* Find a line with attribute " | * Find a line with attribute " | ||
+ | |||
+ | ++++ | ||
+ | |||
+ | ++++ How does the Run from Here procedure work? | | ||
+ | |||
+ | In an event of an emergency stop or failure of a mill machine running a program file, it is often useful to be able to open the file back up afterwards and be able to continue from the middle of the program without having to go through all the steps again. This is often complicated by the fact that a large program file consists of many lines of code, making it difficult to easily navigate to the place where the cutting process stopped initially. In order to facilitate finding this spot, the Run from Here process is put in place in myCNC software. | ||
+ | |||
+ | The Run from Here method is described in the following section of the myCNC Screen manual: [[http:// | ||
++++ | ++++ | ||
Line 229: | Line 266: | ||
++++ Why is the knife not turning when using the Tangential Knife profile (X1366V)? | | ++++ Why is the knife not turning when using the Tangential Knife profile (X1366V)? | | ||
+ | |||
+ | {{youtube> | ||
Check that the tangential knife is turned on in the settings. Alternatively, | Check that the tangential knife is turned on in the settings. Alternatively, |
faq.txt · Last modified: 2024/02/20 10:07 by ivan