Differences

This shows you the differences between two versions of the page.

--- mycnc-screen:1366_series_screen_configuration_examples [2019/09/30 11:58] – ivan
+++ mycnc-screen:1366_series_screen_configuration_examples [2019/10/10 09:38] – ivan
@@ Line 1: / Line 1: @@
 ======1366 Series Screen Configuration Examples=====
-The following examples show some of the available settings that were discussed in the [[mycnc:mycnc_screen_configuration|MyCNC Screen Configuration]] manual. As an extremely large variety of possible settings and combinations are available, not every parameter discussed in the main manual is presented in the examples listed below.
+The following examples show some of the available settings that were discussed in the [[mycnc:mycnc_screen_configuration|MyCNC Screen Configuration]] manual. As an extremely large variety of possible settings and combinations are available, not every parameter discussed in the main manual is presented in the examples listed below. If any additional information is required, do not hesitate to reach out on the [[http://forum.pv-automation.com/|myCNC Forum]].
 ====Example 1: Add a button to display the Centring Widget (probe wizard)====
@@ Line 236: / Line 236: @@
  width="70" height="70"
  image="probing/map-z-probe"
- action="generate-z-map"
+ action="zmap-generate"
  type="button" />
@@ Line 242: / Line 242: @@
  width="70" height="70"
  image="probing/map-z-convert" //the probing folder will be taken from the theme folder (ex: xp)
- action="apply-z-map"
+ action="zmap-apply"
  type="button" />