mycnc:adc_mapping
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| mycnc:adc_mapping [2018/09/13 03:38] – pupalaiser | mycnc:adc_mapping [2018/09/13 03:40] – pupalaiser | ||
|---|---|---|---|
| Line 18: | Line 18: | ||
| As you approach the measurement object, the frequency from the sensor increases, and when you move away from the object, the frequency decreases. | As you approach the measurement object, the frequency from the sensor increases, and when you move away from the object, the frequency decreases. | ||
| We have an ET1 controller with (four real inputs of the ADC and two inputs for the counter). | We have an ET1 controller with (four real inputs of the ADC and two inputs for the counter). | ||
| - | Our task is to adjust the height tracking while working on this sensor. | + | Our task is to adjust the height tracking while working on this sensor. </ |
| - | | + | |
| * Decision: | * Decision: | ||
| - Connect the sensor to the input of the counter 1. For this, the inputs ENC1 A and ENC Ā are used.{{ : | - Connect the sensor to the input of the counter 1. For this, the inputs ENC1 A and ENC Ā are used.{{ : | ||
mycnc/adc_mapping.txt · Last modified: 2018/09/13 03:46 by pupalaiser