Differences

This shows you the differences between two versions of the page.

--- mycnc:change_ip_address_of_mycnc_control_board [2017/07/03 11:53] – skirillov
+++ mycnc:change_ip_address_of_mycnc_control_board [2024/01/25 11:51] (current) – ivan
@@ Line 1: / Line 1: @@
-==== Change IP Address of myCNC control board ====
+====== Change IP Address of myCNC control board ======
+{{youtube>mCahGVvQ_Tw?large}}
+//NOTE: Most modern myCNC control boards (past 2017) have the default IP address of 192.168.4.78.//
 . Connect Host Computer with myCNC controller with USB cable.
-. Open Console window on Host Computer.
+. Open Console window on Host Computer. If you have ARM (Odroid-C2/Raspberry/NanoPi-K2) Single Board Computer (SBC) purchased from us, click on **Terminal MATE** icon on Desktop
+{{mycnc:mycnc-terminal.png}}
 . Run "minicom" software (for ARM(Odroid-C2)/Desktop Linux)
@@ Line 9: / Line 14: @@
 {{minicom-x.png}}
-. Run command in terminal window to change IP address <code>#SLA 192 168 0 78</code> to change IP address to 192.168.0.78. Controller will reply <code>C<D: #SLA 192 168 0 78</code> {{minicom-x-1.png}}
+. Run command in terminal window to change IP address <code>#SLA 192 168 0 78</code> to change IP address to 192.168.0.78. Controller will reply <code>CMD: #SLA 192 168 0 78</code> {{minicom-x-1.png}}
 . If success, controller will reply with message <code>IP:  192.168.000.078</code>{{minicom-x-2.png}}
+. Close Terminal Window.