mycnc:closed_loop_configuration
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:closed_loop_configuration [2018/10/09 13:17] – skirillov | mycnc:closed_loop_configuration [2018/10/09 14:02] – skirillov | ||
---|---|---|---|
Line 40: | Line 40: | ||
For Analogue closed loop system this ratio should be " | For Analogue closed loop system this ratio should be " | ||
- | * Adjust DAC offset ratio to get " | + | * Adjust DAC offset ratio to get " |
* Fill Encoder channel for each PID (Motor#). \\ {{mycnc: | * Fill Encoder channel for each PID (Motor#). \\ {{mycnc: | ||
* To test selected channel, check " | * To test selected channel, check " |
mycnc/closed_loop_configuration.txt · Last modified: 2019/11/05 08:54 by ivan