mycnc:stop_end_program
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:stop_end_program [2019/10/28 12:12] – created ivan | mycnc:stop_end_program [2019/10/28 12:50] – ivan | ||
---|---|---|---|
Line 64: | Line 64: | ||
};</ | };</ | ||
+ | As can be seen, while the M02.plc procedure will have some sort of lift control to prevent issues do to the working tool potentially coming into contact with the working material/ | ||
+ | Additionally, | ||
+ | <code C __HANDLER_GCODE_STOP> | ||
+ | { | ||
+ | exit(99); | ||
+ | }; | ||
+ | </ | ||
+ | Therefore, in a default configuration, | ||
+ | |||
+ | <code C __HANDLER_GCODE_STOP> | ||
+ | { | ||
+ | portclr(3); | ||
+ | exit(99); | ||
+ | }; | ||
+ | </ | ||
+ | |||
+ | In non-default configurations, |
mycnc/stop_end_program.txt · Last modified: 2024/02/21 13:54 by ivan