myCNC Online Documentation

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Triggers/Timers ======
Main window:
{{ :mycnc:trigers_01.png?nolink |}}
Basic functions:
{{ :mycnc:trigers.png?nolink |}}
===== Triggers =====
  * To activate the trigger  , it is necessary to check the box next to number of trigger:{{ :mycnc:2018-08-17_12-28-28.jpg?nolink |}}
  * Then select the type of triggering the trigger.{{ :mycnc:2018-08-17_12-28-36.jpg?nolink |}}
  * **__//Faling Edge //__** - Trigger triggering on the falling edge of the impulse, i.e. when passing from the upper state ("1") to the lower state ("0").{{ :mycnc:edge.png?nolink&600 |}}
  * **__//Rising Edge //__** - Trigger triggering on the rising edge of the impulse, i.e. when passing from the lower  state ("0") to the upper state ("1").{{ :mycnc:edge1.png?nolink&600 |}}
  * After tripping, you can select the controller's output{{ :mycnc:2018-08-17_12-28-53.jpg?nolink |}}
  * You can also choose to start the necessary procedure for triggering the trigger{{ :mycnc:2018-08-17_12-29-29.jpg?nolink |}}
===== Timers =====

  * To activate the timer  , it is necessary to check the box next to number of timer:{{ :mycnc:2018-08-17_12-30-19_2_.jpg?nolink |}}
  * After activating the timer, it is necessary to select the operating output of the controller{{ :mycnc:2018-08-17_12-30-19_3_.jpg?nolink |}}
  * You must select the duration of the output pulse and the length of the pause. Values are set in ms:
__//Timer 0 schedule//__ {{ :mycnc:timers_1.png?nolink &600 |}}
__//Timer 1 schedule//__ {{ :mycnc:timers_2.png?nolink&600 |}}