Differences

This shows you the differences between two versions of the page.

--- mycnc:wireless_pendants [2019/07/26 10:39] – ivan
+++ mycnc:wireless_pendants [2019/07/26 11:26] – ivan
@@ Line 19: / Line 19: @@
 ^ Option ^ Description ^
-| CNC Action |  |
+| CNC Action | This brings up a preset action (listed in [[http://cnc42.com/mycnc/mycnc_screen_configuration?s[]=actions#mycnc_actions|MyCNC Actions list]] |
 | CNC Variable: Switch |  |
 | CNC Variable: Toggle |  |
@@ Line 60: / Line 60: @@
 | Key release | Simulates a key release |
 | (Dlg)Key Press | Simulates a dialog key press, such as Shift, Enter, Delete, 0-9, etc |
-| Move to toolpath |  |
+| Move to toolpath | Move back to the toolpath |
 | Parking position: Save | Save the current position as the parking position |
 | Parking position: Move to | Move to the parking position |
 | Pendant: Axis (*) |  |
 | Pendant: Mul (*) |  |
-| Pendant: Wheel CW |  |
+| Pendant: Wheel CW | Record the input as wheel moving clockwise |
-| Pendant: Wheen CCW |  |
+| Pendant: Wheel CCW | Record the input as wheel moving counter-clockwise |
 | Pendant: Mul increment |  |
 | Pendant: Mul decrement |  |
 | Pendant: Axis change + |  |
 | Pendant: Axis change - |  |
-| Pendant0: x0.001-1 |  |
+| Pendant0: x0.001-1 | Sets the increment for the machine movements which is controlled by the pendant |
 | Pendant0: Axis off |  |
-| Pendant0: Axis X-C |  |
+| Pendant0: Axis X-C | Sets the axis that the pendant will be sending commands to |
 | Pendant: Work coordinate Half | Takes the pendant work coordinate (in the axis specified on the pendant) and halves it |
 | Pendant: Work coordinate Reset | Resets the work coordinate specified in the pendant axis |
@@ Line 79: / Line 79: @@
 | PLC: Run external unit procedure | Run a PLC procedure on a slave controller. The syntax for the command will be as follows: controller number / command / variable (for example, 0x01/M74/#7009) |
 | Run Numpad |  |
-| Show: Pendant control widget |  |
+| Show: Pendant control widget | Brings up the pendant control widget in the myCNC software |
 | Select axis | Select the particular axis |
 | Show: Widget | Shows a particular widget, such as Library Shape, Diagnostics, Config, etc |
@@ Line 91: / Line 91: @@
 | Toggle Machine/Work DRO (if applicable) |  |
 | Toggle Jog enable/disable | Turn jog on and off |
-| Toggle Jog mode unlimited/step | Switch between  |
+| Toggle Jog mode unlimited/step | Switch between the unlimited and a set step jog for machine movements |
 | Toggle Soft Limits enable/disable | Turn the soft limits (specified in Inputs/Outputs/Sensors > Limits) on and off |
 | Toggle Flood on/off | Turns the liquid cooling (flood) on and off |