troubleshooting:camera_troubleshooting
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
troubleshooting:camera_troubleshooting [2020/01/16 14:09] – ivan | troubleshooting:camera_troubleshooting [2021/12/13 16:42] (current) – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
======Camera Troubleshooting====== | ======Camera Troubleshooting====== | ||
- | The full manual on regular camera setup is available here: [[quickstart: | + | The full manual on regular camera setup for Optical Registration Mark Reading |
The steps described in this manual are typically not required to set up a camera purchased from Puruvesi Automation, since the camera comes pre-configured out of the box, and should be used only in situations when access to deep camera settings is required. | The steps described in this manual are typically not required to set up a camera purchased from Puruvesi Automation, since the camera comes pre-configured out of the box, and should be used only in situations when access to deep camera settings is required. | ||
Line 44: | Line 44: | ||
* In the Video Coding window, check that the Coding field is set to MJPEG for best image recognition results when using the myCNC Vision System. Here you can also change the resolution and the frame rate of the camera. Typically, a frame rate of around 10 frames/sec is sufficient for the myCNC Vision System. Click ' | * In the Video Coding window, check that the Coding field is set to MJPEG for best image recognition results when using the myCNC Vision System. Here you can also change the resolution and the frame rate of the camera. Typically, a frame rate of around 10 frames/sec is sufficient for the myCNC Vision System. Click ' | ||
{{: | {{: | ||
+ | |||
+ | =====Adding/ | ||
+ | |||
+ | The XML code responsible for displaying the camera cross/ | ||
+ | |||
+ | <code XML>< | ||
+ | | ||
+ | | ||
+ | | ||
+ | </ | ||
+ | |||
+ | The following options are available: | ||
+ | * center-lines: | ||
+ | * center-circle: | ||
+ | * show-roi: show Region of Interest (described in the main Camera manual: [[quickstart: | ||
+ | |||
+ | For more information on XML editing, please consult the following manual: [[mycnc: |
troubleshooting/camera_troubleshooting.txt · Last modified: 2021/12/13 16:42 by ivan