troubleshooting:camera_troubleshooting
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
troubleshooting:camera_troubleshooting [2020/07/13 12:50] – ivan | troubleshooting:camera_troubleshooting [2021/12/13 16:42] (current) – ivan | ||
---|---|---|---|
Line 44: | Line 44: | ||
* In the Video Coding window, check that the Coding field is set to MJPEG for best image recognition results when using the myCNC Vision System. Here you can also change the resolution and the frame rate of the camera. Typically, a frame rate of around 10 frames/sec is sufficient for the myCNC Vision System. Click ' | * In the Video Coding window, check that the Coding field is set to MJPEG for best image recognition results when using the myCNC Vision System. Here you can also change the resolution and the frame rate of the camera. Typically, a frame rate of around 10 frames/sec is sufficient for the myCNC Vision System. Click ' | ||
{{: | {{: | ||
+ | |||
+ | =====Adding/ | ||
+ | |||
+ | The XML code responsible for displaying the camera cross/ | ||
+ | |||
+ | <code XML>< | ||
+ | | ||
+ | | ||
+ | | ||
+ | </ | ||
+ | |||
+ | The following options are available: | ||
+ | * center-lines: | ||
+ | * center-circle: | ||
+ | * show-roi: show Region of Interest (described in the main Camera manual: [[quickstart: | ||
+ | |||
+ | For more information on XML editing, please consult the following manual: [[mycnc: |
troubleshooting/camera_troubleshooting.txt · Last modified: 2021/12/13 16:42 by ivan